Apex Filter Stop & Non-Return (3-in-1) Valve - FS15

Model: FS15

Application:

• Low and High (Mains) Pressure Systems
• Any application where filter, non-return or isolating valve is required.  

Standards:

• Complies with NZ Building Code G12 (2001)
• Complies with NZS 4608:1992
• NZ Patent No. 230940
• Aust Patent No. 625338  

• Compact 3-in-1 valve (filter, isolating and non-return) with high flow rates.
• No tools required to service the valve
• All servicing can be done with water supply on
• N.Z. forged, high quality, corrosion resistant DR brass body.
• Machined, assembled and 100% tested in N.Z

Flow Chart:

Installation:

• Refer to Specifcations Tab for Installation Guide
• Can be installed in any orientation but is best with filter bowl down for ease of cleaning.
• Do NOT install in the ground.
• Do NOT apply heat near the valve during installation

Servicing:

The filter may be cleaned without the need to isolate water supply, no tools required.

1. Turn handle clockwise to close valve
2. Remove filter bowl
3. Remove and clean filter
4. Refit filter, filter bowl and turn on fully

Inlet: 15mm, 1/2" BSP (male) 

Outlet: 15mm, 1/2" BSP (female)

Length: 86mm

• 60 mesh (250 micron), stainless steel filter
• Non-return check valve cartridge
• Maximum inlet pressure:
  • Plastic Cap: 1000 kPa [145psi] @ 40°C
  • Brass Cap: 2000 kPa [290psi] @ 99°C
• Minimum temperature: 1˚C.
• DR (Dezincification Resistant) brass.

Downloads
	Apex Catalogue