Apex Filter Stop & Non-Return (3-in-1) Valve 20mm - FS20
POA
Model: FS20
FS20 - 20mm Filter Stop & Non-Return (3-in-1) Valve
Application:
- Low and High (Mains) Pressure Systems
- Any application where filter, non-return or isolating valve is required.
Standards:
- Complies with NZ Building Code G12 (2001)
- Complies with NZS 4608:1992
- NZ Patent No. 230940
- Aust Patent No. 625338
- Compact 3-in-1 valve (filter, isolating and non-return) with high flow rates.
- No tools required to service the valve
- All servicing can be done with water supply on
- N.Z. forged, high quality, corrosion resistant DR brass body.
- Machined, assembled and 100% tested in N.Z
Flow Chart:
Installation:
- Refer to Specifcations Tab for Installation Guide
- Can be installed in any orientation but is best with filter bowl down for ease of cleaning.
- Do NOT install in the ground.
- Do NOT apply heat near the valve during installation
Servicing:
The filter may be cleaned without the need to isolate water supply, no tools required.
- Turn handle clockwise to close valve
- Remove filter bowl
- Remove and clean filter
- Refit filter, filter bowl and turn on fully
Inlet: 20mm, 3/4" BSP (male)
Outlet: 20mm, 3/4" BSP (male)
Length: 88mm
- 60 mesh (250 micron), stainless steel filter
- Non-return check valve cartridge
-
Maximum inlet pressure:
- Plastic Cap: 1000 kPa [145psi] @ 40°C
- Brass Cap: 2000 kPa [290psi] @ 99°C
- Minimum temperature: 1˚C.
- DR (Dezincification Resistant) brass.
| Downloads | |
 |
Apex Catalogue |
