Reliance High Pressure and Temperature Relief Valve with 1" Extension 15mm 700kPa - HTE501

Model: HTE501

Reliance High Pressure and Temperature Relief Valve with 1" Extension 15mm 700kPa - HTE501

RMC's HT Series valves are for use on mains pressure water heaters. They are available in a range of pressure settings from 500 kPa to 1400 kPa, and in 15 mm and 20 mm nominal diameters. Also available are extended shank models and versions with a hot water take-off.

RMC’s Pressure and Temperature Relief (P & T Relief) Valves are safety controls which ensure that the temperature of the water in a pressurised unvented water heater cannot exceed 99° C in the event that the normal thermostatic controls fail. These valves may be used to guard against overtemperature and over-pressure hazards wherever water is stored in unvented containers. This is a requirement of Australian Standard AS 3500-4. RMC P & T Relief Valves are available in 15 mm and 20 mm confi gurations.  

• Auxiliary pressure relief device
  Prevents pressure building up in the event of a blockage in the drain line
• Female BSP thread on outlet thread
  Prevents incorrect installation to the tank
• Plastic coated temperature probe
  Prevents electrolysis of the probe outer casing
• Dezincification resistant
  Meets Australian Standard for potable water supply

The Pressure and Temperature Relief (P & T Relief) Valve should be installed at the heater. System inlet pressure should be no higher than 80% of the set pressure of the P & T Relief Valve. Please ensure that the set pressure of the High Pressure Expansion Control Valve is suitable for use with the water heater it will be installed with. For more information refer to the RMC Valve Application Guide.

• Inlet (MI): 15mm
• Outlet (FI): 15mm
• Hotwater takeoff: N/A
• Kilowatt Capacity: 10Kw
• Maximum Tempreture: 99°C
• Std Pressure Settings Available (kPa): 700, 850, 1000 & 1400

Downloads
	Temperature Relief Valves
	HT/HTT/HTE Series - P & T Relief Valve Technical Specifications