Dux Storm Drain End Cap with Outlet - R3408
POA
Model: R3408
Dux distributes the complete range of Surface Water Drainage Products to meet your drainage needs around the home or your commercial applications:
- Manufactured from tough, durable, UV stabilised recycled plastics
- Range of grates to suit a broad range of applications
-
Range of sizes for any surface water solution or application
- Dux Storm Drain End Cap with Outlet - R3408
- Form trench for Reln Storm Drain allowing for 50mm bed of packed sand.
- If Reln Storm drain will be subject to vehicle traffic, surround in concrete.
- Allow slope of approx. 30cm to every 20m.
- Join Reln Storm Drain, joins and end caps may be sealed with silicone.
- Use Reln end cap at highest point of Reln Storm Drain.
- Connect the low end of the Storm Drain to a Rainwater pit, or, using 90mm PVC pipe use built in Bottom Outlet, or fit an End Outlet to allow water to clear.
- Lay Storm Drain out with corner piece connected and end cap fitted prior to concreting.
- Storm Drain can be cut to length with a hacksaw, install with grate fitted.
- Protect grate with masking tape during concrete pour.
- Top of grate must be 2mm below concrete or paver surface.
- Flat grate surface for safe pedestrian, bike and wheelchair traffic.
- Diagonal slots allow faster drainage.
- Textured surface for extra grip.
- Withstands 5 tonne vehicle without moving in concrete.
- Cross braced design prevents floating when concreting and movement once set.
- Bottom outlet is an advantage when the slope is slight.
- It also allows more concrete over pipe when paving.
- Available in 1 and 3 metre lengths. 3 metre length means less work, fewer joins, less cost.
- Male/female ends on channel allow snap together joining.
- Rounded base assists rapid water flow with self-cleaning.
- End cap closes off end, and End Outlet connects to 90mm stormwater pipe.
- Stainless steel and ductile iron grates also available.
- Also available upon request, Storm Drain Civil range able to withstand 15 tonne loading.
